News Center
IEC specifications Disposal equipment

IEC specifications Disposal equipment

IEC 60480 - Specifications for the re-use of sulphur hexafluoride (SF6) and its mixtures in electrical equipment Published by IEC on April 1, 2019 This document provides criteria for the re-use of sulphur hexafluoride (SF6) and its mixtures after recovery and reclaiming from electrical equipment (e.g. for maintenance, at the end-of-life)....

[email protected]

News Detail

  • Annex (A) Technical Specifications for Distribution

    The equipment shall comply with the latest editions and amendments of the international standards listed below as a minimum. IEC International Electrotechnical Commission: IEC 60071: Insulation co-ordination IEC 60076: Power transformers IEC 60137: Bushing for alternating voltages above 1,000V

    Get Price
  • Medical Device Marking and Labeling Regulations

    An operators manual must identify any risks associated with the disposal of waste products or residues generated during use. It must also provide advice on minimizing associated risks. IEC 60601-1 also requires identifying risks associated with the disposal of the equipment and its accessories (at the end of

    Get Price
  • Standards IECEx

    Standards Documentation for Purchase. The IECEx System is based on the use of International Standards, such as IEC Standards. These Standards are dedicated to the highly specialised fields associated with the use of equipment, termed Ex equipment, and installations in areas where a potential may exist of fire or explosion.

    Get Price
  • Equipment Verification (to IEC Standards)

    Project specifications will often say equipment needs to be manufactured to xyz standard and often stop at that. To fully understand the requirements you need to know what is in xyz standard – which means reading it. The IEC standards in general are pretty good as giving performance requirements and listing the necessary testing and

    Get Price
  • IEC Specifications for SF6 Gas

    Relevant IEC specifications/norms for SF6 gas are: IEC 60376 for new gas, IEC 60480 for used SF6 gas and IEC 62271-4 as SF6 reuse specification.

    Get Price
  • 4th Edition - WHO

    IEC International Electro Commission Volume 3: Specifications for the Equipment and Furniture and disposal of medical equipment, bearing in mind cost-effectiveness and appropriateness of technology. Presently the task of nAcME is advisory while Health

    Get Price
  • IEC 60944 : 1.0 GUIDE FOR THE MAINTENANCE OF SILICONE

    bs en 50503 - fluids for electrotechnical applications - standard for the inventory control, management, decontamination and/or disposal of electrical equipment and insulating liquids containing pcbs: bs en 60836 : 2015 : specifications for unused silicone insulating liquids for electrotechnical purposes: 12/30269145 dc : 0

    Get Price
  • IEC 60068-2 | Environmental Testing of Electronic Equipment

    IEC 60068-2-27 is intended for equipment or products that could be subjected to infrequent or repetitive shocks during storage, use or transportation. It is designed to uncover mechanical weaknesses and/or degradation caused by those shocks.

    Get Price
  • List of International Electrotechnical Commission

    This is an incomplete list of standards published by the International Electrotechnical Commission (IEC).. The numbers of older IEC standards were converted in 1997 by adding 60000; for example IEC 27 became IEC 60027. IEC standards often have multiple sub-part documents; only the main title for the standard is listed here.

    Get Price
  • IECEE CTL | Testing Equipment: Overview

    Overview Committee of Testing Laboratories. When a new IEC Standard is approved under the IECEE Scheme, the relevant expert task force in the Committee of Testing Laboratories (CTL) prepares a list for testing and measuring equipment that is required in order to operate for the Standard in question.

    Get Price
  • INTERNATIONAL IEC STANDARD 60296

    IEC 60247, Measurement of relative permittivity, dielectric dissipation factor and d.c. resistivity of insulating liquids IEC 60422, Supervision and maintenance guide for mineral insulating oils in electrical equipment IEC 60475, Method of sampling liquid dielectrics IEC 60628, Gassing of insulating liquids under electrical stress and ionization

    Get Price
  • ISO - 11.140 - Hospital equipment

    11.140 Hospital equipment Including hospital beds, surgical tables, medical garments, medical gloves, containers for sharp disposal, etc.

    Get Price
  • Understanding IEC 60601-1-12: Requirements for Emergency

    Jul 15, 2019Authorities are increasingly adopting IEC 60601-1-12 as the standard for Emergency Medical Service (EMS) equipment. Manufacturers need to understand its requirements to deliver safe and compliant products to the marketplace. IEC 60601-1-12 was released in 2014. It covers the basic safety and essential performance requirements for medical

    Get Price
  • IEC 60376 - Specification of technical grade sulphur

    IEC 60480 - Specifications for the re-use of sulphur hexafluoride (SF6) and its mixtures in electrical equipment Published by IEC on April 1, 2019 This document provides criteria for the re-use of sulphur hexafluoride (SF6) and its mixtures after recovery and reclaiming from electrical equipment (e.g. for maintenance, at the end-of-life)....

    Get Price
  • Homepage | IEC

    The Market Strategy Board (MSB) was set up by the IEC to identify the principal technological trends and market needs in the IEC fields of activity. The MSB publishes recommendations – white papers – in a form that differs from International Standards.

    Get Price
  • TECHNICAL ISO/IEC SPECIFICATION TS 17021-2

    — an ISO/IEC Technical Specification (ISO/IEC TS) represents an agreement between the members of a technical committee and is accepted for publication if it is approved by 2/3 of the members of the committee casting a vote. An ISO/PAS or ISO/TS is reviewed after three years in order to decide whether it will be confirmed for a

    Get Price
  • Technical Specification for Power Transformers

    IEC 296 335 Specification for unused mineral oils for transformers and switchgear. IEC 354 6600 Loading Guide for oil immersed transformers. IEC 437 Radio Influence Voltage measurement. IEC 518 Dimensional standardisation of terminals for high voltage switchgear and control gear. IEC 529 2147 Degrees of protection provided by enclosures.

    Get Price
  • IEC 60571 - Railway applications – Electronic equipment

    In such a case (i.e. software safety integrity level 1 or higher), IEC 62279 is applicable. For the purpose of this standard, electronic equipment is defined as equipment mainly composed of semiconductor devices and recognized associated components. These components will mainly be mounted on printed boards.

    Get Price
  • IEC 60950-1 Information technology equipment – Safety

    IEC 60950-1 Information technology equipment – Safety – Part 1: General requirements Verity Electronics Specification 4005461 (37) Attachment 5 – Verity Operational Guide 6640001 (68) Attachment 6 – Verity Polling Place Operations Technical Reference manual 6610-100 (101)

    Get Price
  • IEC 60376 PDF - I Cool PDF

    May 26, 2020BS EN IEC 60376:2018. This third edition cancels and replaces the second edition published in We use cookies to make our website uec to use and to better understand your needs. Specification of technical grade sulphur hexafluoride SF6 and complementary gases to be used in its mixtures for use in electrical equipment.

    Get Price
  • IEC 60480 Ed. 3.0 b:2019 - Specifications for the re-use

    IEC 60480 Ed. 3.0 b:2019 Specifications for the re-use of sulphur hexafluoride (SF 6) and its mixtures in electrical equipment. IEC 60480:2019 provides criteria for the re-use of sulphur hexafluoride (SF 6) and its mixtures after recovery and reclaiming from electrical equipment (e.g. for maintenance, at the end-of-life). Sulphur hexafluoride (SF 6), nitrogen (N 2) and carbon tetrafluoride (CF

    Get Price
  • IEC-60115-1 | Fixed resistors for use in electronic

    IEC 60115-1:2020 is a generic specification and is applicable to fixed resistors for use in electronic equipment. It establishes standard terms, inspection procedures and methods of test for use in sectional and detail specifications of electronic components for quality assessment or any other purpose.

    Get Price
  • Hazarouds Area Standards List | IEC BS EN | 1957 - Present

    A comprehensive table of all hazardous area standards including IEC, BS and EN. 60079, 61508, Ex d, e, D etc. 1957 - Present.

    Get Price
  • IEC 61125 : 1.0 INSULATING LIQUIDS - TEST METHODS FOR

    specification for laminated pressboard - part 2: methods of test: bs en 60079-6 : 2007 : explosive atmospheres - part 6: equipment protection by by liquid immersion o clc/tr 50503 : 2010 : guidelines for the inventory control, management, decontamination and/or disposal of electrical equipment and insulating liquids containing pcbs: i.s. en

    Get Price
  • IEC 60480 PDF - PDF Calanes

    Jul 24, 2019IEC Standard | Specification of technical grade sulphur hexafluoride (SF 6) and complementary gases to be used in its mixtures. IEC Ed. Guidelines for the checking and treatment of sulfur hexafluoride (SF6) taken from electrical equipment and specification for its re-use . IEC High-voltage switchgear and controlgear – Part Gas- .

    Get Price
  • Common external power supply - Wikipedia

    In 2009, a European Commission initiative resulted in the specification of a common external power supply (common EPS) for use with data-enabled mobile phones sold in the European Union.The external power supply is the AC electric power adapter that converts household AC electricity voltages to the much lower DC voltages needed to charge a mobile phones internal battery.

    Get Price
  • The SF6-ReUse-Process A contribution on the sustainability

    Disposal Case . exists when the used SF. 6 . does not fulfill the SF. 6 – ReUse – Specification. Table 1 : Solvay product specification, IEC 60376 specification and ASTM specification for new SF6 analysis of liquid phase[3] Table 2 : SF. 6 – ReUse – Specification. 2.3 D. isposal Case . When a Disposal Case arises, the used SF. 6

    Get Price
  • Advanced Search | IEC Webstore

    Keep up to date with new publication releases and announcements with our free IEC Just Published email newsletter. Contact customer services Please send your enquiry by email or call us on +41 22 919 02 11 between 09:00 – 17:00 CET Monday to Friday.

edge-iconRelated News
toTop
Click avatar to contact us
Chat Online